Ryobi RLS1351 Manuel d'utilisateur télécharger pdf (Page 16)

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts may create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked

to comply with ANSI Z87.1 during product operation. If

operation is dusty, also wear a dust mask.

WARNING:

Before performing any maintenance, make sure the tool

is unplugged from the power supply and the switch is

in the OFF position. Failure to heed this warning could

result in serious personal injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake ﬂuids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken, or

destroy plastic which may result in serious personal injury.

 Periodically check all clamps, nuts, bolts, and screws for

tightness and condition. Make sure the throat plate is in

good condition and in position.

 Check the blade guard.

 Clean the fence and rails with a gum and pitch remover.

 Clean plastic parts only with a soft damp cloth. DO

NOT use any aerosol or petroleum solvents.

LUBRICATION

All of the bearings in this tool are lubricated with a sufﬁcient

amount of high grade lubricant for the life of the unit under

normal operating conditions.

Some areas will require lubrications. You will need to

apply:

 Light oil or a pressurized light spray oil to the sliding

rails.

TO REMOVE / REPLACE THE THROAT PLATE

See Figure 23, page 22.

WARNING:

The throat plate must be below the saw table. If the throat

plate is too high or too low, the workpiece can catch on

the uneven edges resulting in binding which could result

in serious personal injury.

Never operate the saw without a throat plate installed.

To remove / replace:

 Unplug the saw.

 Remove the screws securing the throat plate.

 Lift the throat plate from the saw. Repeat the above

steps for the left side of the throat plate.

 To reinstall the throat plate, align the holes in the throat

plate with the holes in the saw base.

 Retighten the screws, being careful not to overtighten

which can cause the throat plate to bow or bend.

The following recommended accessories are currently available at retail stores:

089230100053 Saw Blade

WARNING:

Current attachments and accessories available for use with this tool are listed above. Do not use any attachments or ac-

cessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended

can result in serious personal injury.

ACCESSORIES

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Ryobi RLS1351 Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi RLS1351