Ryobi RTS21 Manuel d'utilisateur télécharger pdf (Page 19)

ASSEMBLY

TO ASSEMBLE THE SLIDING TABLE

ASSEMBLY

See Figures 17 - 18.

To install sliding table assembly:

 Locate the sliding table assembly.

 Unlock the front and back table locking levers.

 Insert sliding table assembly into table locking levers.

 Push the table assembly until it rests against the saw

table and is completely closed.

 Install phillips head screw into hole on the bottom of the

rear extension rod to hold sliding table assembly into

locking levers.

 Lock the front and back table locking levers.

To install indicator:

 Press the end cap over the front extension rod as shown

in figure 18.

 Locate the indicator.

 Slip the indicator in the slot on the front rail.

 Fit the top slot in the indicator over the detent on the end

plug and the bottom slot over the screw hole on the end

plug.

 Insert a screw into the bottom slot of the indicator, the hole

in the end plug and the extension rod. Tighten securely,

but do not overtighten. Overtighting may crush extension

rod ends.

Fig. 18

SCREW

INDICATOR

TABLE

LOCKING

LEVER

REAR

EXTENSION ROD

EXTENSION

ROD

Fig. 17

END CAP

SLIDING

TABLE

ASSEMBLY

DETENT

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

Pas de commentaire

Ryobi RTS21 Manuel d'utilisateur Page 19