Ryobi SC164VS Manuel d'utilisateur télécharger pdf (Page 14)

ASSEMBLY

SQUARING THE SAW TABLE TO THE BLADE

See Figure 7 - 8.

 Loosen the drop foot lock knob and move drop foot rod

all the way up. Retighten drop foot lock knob.

 Loosen the table lock knob to tilt the saw table until it

is approximately perpendicular or at right angle to the

blade.

 Place a small square on the saw table next to the

blade.

 Loosen the screw holding the scale indicator. Move indica-

tor to the 0° mark and securely tighten screw. Remember,

the bevel scale is a convenient guide but should not be

relied upon for precision. Make practice cuts on scrap

material to determine if your angle settings are correct.

 Adjust the drop foot to desired position and securely

retighten the drop foot lock knob.

SETTING THE TABLE FOR HORIZONTAL OR

BEVEL CUTTING

See Figure 7 - 8.

A bevel scale is located under the saw table as a convenient

guide for setting the approximate saw table angle for bevel

cutting. When greater precision is required, make practice

cuts on scrap material and adjust the saw table as necessary

for your requirements.

NOTE: When cutting at angles, the drop foot should be

tilted so it is parallel to the saw table and rests flat against

the workpiece. To tilt the drop foot, loosen phillips screw, tilt

drop foot to the proper angle, then retighten screw.

 Loosen the drop foot lock knob.

 Center the drop foot around the saw blade to the desired

position.

 Tighten the drop foot lock knob.

Fig. 7

DROP

FOOT

SMALL

COMBINATION

SQUARE

DROP FOOT ROD

TABLE LOCK KNOB

DROP FOOT

LOCK KNOB

OFF

Fig. 8

TABLE LOCK KNOB

BEVEL SCALE

SCALE

INDICATOR

SCREW

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21 22

Commentaires sur ces manuels

Pas de commentaire

Ryobi SC164VS Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi SC164VS