Ryobi TS1355L Manuel d'utilisateur télécharger pdf (Page 32)

MAINTENANCE

Fig. 46

negative (–)

laSer guiDe

SuPPort

BatterieS

CHANGING THE BATTERIES

See Figures 45 - 46.

 Unplug the saw.

Remove the laser guide from the saw and lay it on a flat

surface with the two phillips screws facing upward.

Remove the screws and separate the laser guide cover

from the laser guide support.

Remove the three button cell batteries using a non-con-

ductive device such as a toothpick.

NOTE: Replace the batteries with silver oxide batteries that

have a rating of 1.5 volt and 180 mah (milliampere hour)

minimum (Number 357 silver oxide only).

When replacing the batteries, the laser guide should be

thoroughly cleaned. Use a soft paintbrush or similar device,

to remove all sawdust and debris.

Do not attempt to activate the laser.

The laser is activated by means of a centrifugal switch

only while the saw motor is running and the laser guide is

mounted on the saw.

After cleaning the laser guide and replacing the batteries,

secure the laser guide cover to laser guide support using

the two phillips head screws. For proper assembly, be sure

to align the key on the laser guide cover with the key slot

in the laser guide support. Tighten screws securely.

NOTE: Aperture in laser guide cover must be aligned with

aperture in laser guide support.

WARNING:

Use of controls or adjustments or performance of

procedures other than those specified herein may result

in hazardous radiation exposure.

Fig. 45

DANGER: Laser radiation when open and inter-

lock defeated. AVOID DIRECT EYE EXPOSURE.

ScrewS

laSer guiDe

cover

laSer guiDe

keY

Slot

aPerture

laSer guiDe

SuPPort

(uPSiDe Down view)

keY

PlaStic

BatterY

inSulator

ANGER

1 2 ... 27 28 29 30 31 32 33 34

Commentaires sur ces manuels

Pas de commentaire

Ryobi TS1355L Manuel d'utilisateur Page 32

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi TS1355L