Ryobi TS1552DXL Manuel d'utilisateur télécharger pdf (Page 16)

ASSEMBLY

REAR BRACKET

See Figure 12.

WARNING:

A rear bracket is included with this miter saw to prevent

tipping if the saw arm is released suddenly. Do not use

this saw before installing the rear bracket and securely

mounting the saw to a work surface.

n Standing behind the mounted miter saw, slide the rear

bracket in the holes at the base of the saw.

n Secure in place using hex nuts.

n Tighten securely.

TABLE EXTENSIONS

See Figures 13 - 14.

To use the stop block, slide the stop block on the back arm

of the desired table extension first.

To install table extensions, insert the ends of extensions

into the holes in the sides of the base. See Figures 13 - 14.

Adjust the extensions to the desired length.

Secure extensions in place by positioning a clamp bracket

under each table extension beneath the miter table. Orient

each clamp bracket as shown in figure 14.

Secure each clamp bracket in place with a clamp bracket

screw. The clamp bracket screw threads through the clamp

bracket and tightens against bracket support on bottom of

miter table, securing clamp bracket against table extension.

Fig. 12

REAR

BRACKET

HEX

NUT

BASE

Fig. 13

Fig. 14

CLAMP

BRACKET SCREW

SAW VIEWED FROM BOTTOM

CLAMP

BRACKET

CLAMP

BRACKET

ASSEMBLED

TABLE

EXTENSION

BRACKET

SUPPORT

MITER

SAW BASE

MITER

SAW

BASE

TABLE

EXTENSION

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 33 34

Commentaires sur ces manuels

Pas de commentaire

Ryobi TS1552DXL Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi TS1552DXL