Ryobi WS750L Manuel d'utilisateur télécharger pdf (Page 16)

16 — English

WARNING:

Before performing any adjustment, make sure the tool is

unplugged from the power supply and the switch is in the

OFF position. Failure to heed this warning could result in

serious personal injury.

The saw has been adjusted at the factory for making very

accurate cuts. However, some of the components might

have been jarred out of alignment during shipping. Also,

over a period of time, readjustment will probably become

necessary due to wear.

Do not start any adjustments until you have checked with

a square and made test cuts to be sure adjustments are

needed.

TO SQUARE THE CUTTING WHEEL TO THE

TABLE

See Figure 32, page 26.

Do not loosen any screws for this adjustment until you have

checked with a square and made test cuts to be sure adjust-

ments are necessary. Once the screws are loosened, these

items must be reset.

 Unplug the saw.

 Using a 13 mm wrench or adjustable wrench (not included),

loosen the hex bolt at the front of the frame and end of

the slide rod.

 Move the table until the fence is square with the cutting

wheel.

 Tighten the hex bolt securely.

TO ADJUST THE TABLE ROLLERS

See Figure 33, page 26

If the table doesn’t slide smoothly, seems too loose on

the slide rod, or moves side to side, adjustments may be

required. There are two different sets of shafts that may

require adjustment.

To adjust if the table is loose:

 Using a hex key and wrench (not included), loosen the

bottom two shafts. These lower shafts can be adjusted

up and down on the slide rod.

 If the table still doesn’t slide smoothly, loosen the top two

shafts.

 Once the rollers are sliding satisfactorily, tighten the

screws securely.

To adjust if the rollers are too tight:

 From the side closest to the frame, insert a hex key in

the shaft.

 Holding the hex key to keep the shaft from turning,

loosen the nylock nuts until the table slides at the desired

smoothness.

ADJUSTMENTS

CAUTION:

Use of controls or adjustments or performance of pro-

cedures other than those specified herein may result in

hazardous radiation exposure.

TO ADJUST THE LASER GUIDE

See Figure 34, page 27.

NOTE: Avoid direct eye exposure when using the laser

guide.

 Unplug the saw.

 Using a marker or grease pencil, mark the material for a

straight 90º cut.

 Place the material on the table and firmly against the rip

guide and fence.

 Turn the laser on.

 Loosen the wheel guard lock and open the wheel

guard.

 To adjust the laser line, loosen the Phillips head screw,

adjust the laser module as needed, and tighten the screw

securely.

 Once aligned, close and lock the wheel guard.

NOTE: Always make practice cuts on scrap material before

cutting through your workpiece.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 59 60

Commentaires sur ces manuels

Pas de commentaire

Ryobi WS750L Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi WS750L