Ryobi CSB144LZK Manuel d'utilisation et d'entretien télécharger pdf (Page 12)

12 - English

OPERATION

TO BEVEL CUT

See Figure 21, page 18.

Hold the saw firmly with both hands as shown.

Rest the front edge of the base on the workpiece.

Start the saw and let the blade reach full speed.

Guide the saw into the workpiece and make the cut.

Release the switch and allow the blade to come to a

complete stop.

Lift the saw from the workpiece.

POCKET CUTTING

See Figure 22, page 18.

WARNING:

Always adjust bevel setting to zero before making a

pocket cut. Attempting a pocket cut at any other setting

can result in loss of control of the saw possibly causing

serious injury.

Adjust the bevel setting to zero and tighten the bevel lock

knob.

Set the blade to the correct blade depth setting.

Swing the lower blade guard up using the lower blade

guard handle.

NOTE: Always raise the lower blade guard with the handle

to avoid serious injury.

Hold the lower blade guard by the handle while keeping

your hand on the front handle as shown.

Rest the front of the base flat against the workpiece with

the rear of the handle raised so the blade does not touch

the workpiece.

Start the saw and let the blade reach full speed.

Guide the saw into the workpiece and make the cut.

WARNING:

Always cut in a forward direction when pocket cutting.

Cutting in the reverse direction could cause the saw to

climb up on the workpiece and back toward you.

Release the switch and allow the blade to come to a

complete stop.

Lift the saw from the workpiece.

Clear corners out with a hand saw or sabre saw.

WARNING:

Never tie the lower blade guard in a raised position.

Leaving the blade exposed could lead to serious injury.

OPTIONAL DUST NOZZLE KIT

See Figure 23, page 19.

You may purchase a dust nozzle kit, part no. 200673002,

for use with the saw. The adaptor fits over the dust chute

which is located on the upper blade guard. The nozzle at-

taches to the adaptor.

NOTE: If you use the nozzle, you should always connect it

to a standard vacuum hose.

To attach the dust nozzle:

Unplug the saw.

Lift lower blade guard.

Orient adaptor to fit into the dust chute opening on upper

blade guard.

Secure adaptor with screw provided.

 Align hole in nozzle with raised lip on adaptor and snap

into place when using a vacuum hose.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB144LZK Manuel d'utilisation et d'entretien Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi CSB144LZK