Ryobi D42 Manuel d'utilisateur télécharger pdf (Page 6)

6 − English

ASSEMBLY

WARNING:

Do not use this product if it is not completely assembled

or if any parts appear to be missing or damaged. Use of

a product that is not properly and completely assembled

or with damaged or missing parts could result in serious

personal injury.

WARNING:

Do not attempt to modify this product or create acces-

sories or attachments not recommended for use with this

product. Any such alteration or modification is misuse

and could result in a hazardous condition leading to

possible serious personal injury.

If any parts are damaged or missing, please call 1-800-525-2579 for assistance.

OPERATION

WARNING:

Do not allow familiarity with products to make you care-

less. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this product. The

use of attachments or accessories not recommended

can result in serious personal injury.

APPLICATIONS

You may use this product for the purposes listed below:

 Drilling in all types of wood products (lumber, plywood,

paneling, composition board, and hardwood)

 Drilling in ceramics, plastics, fiberglass, and laminates

 Drilling in metals

SWITCH TRIGGER

See Figure 1, page 10.

To turn the drill ON, depress the switch trigger. To turn it

OFF, release the switch trigger.

VARIABLE SPEED

The variable speed switch delivers higher speed with

increased trigger pressure and lower speed with decreased

trigger pressure.

NOTE: You might hear a whistling or ringing noise from the

switch during use. Do not be concerned; this is a normal

part of the switch function.

DIRECTION OF ROTATION SELECTOR

(FORWARD/REVERSE/CENTER LOCK)

See Figure 1, page 10.

The direction of bit rotation is reversible and is controlled

by a selector located above the switch trigger. With the drill

held in normal operating position, the direction of rotation

selector should be positioned to the left of the switch trigger

for drilling. The drilling direction is reversed when the selector

is to the right of the switch trigger.

Setting the switch trigger in the OFF (center lock) position

helps reduce the possibility of accidental starting when not

in use.

NOTICE:

To prevent gear damage, always allow the chuck to

come to a complete stop before changing the direction

of rotation.

To stop the drill, release the switch trigger and allow the

chuck to come to a complete stop.

NOTE: The drill will not run unless the direction of rotation

selector is pushed fully to the left or right.

Avoid running the drill at low speeds for extended periods

of time. Running at low speeds under constant usage may

cause the drill to become overheated. If this occurs, cool the

drill by running it without a load and at full speed.

KEYLESS CHUCK

See Figure 2, page 10.

The drill has a keyless chuck that makes it simple to

tighten or release drill bits in the chuck jaws. Grasp and

hold the collar of the chuck with one hand. Rotate the chuck

body with your other hand. The arrows on the chuck indicate

which direction to rotate the chuck body in order to LOCK

(tighten) or UNLOCK (release) the drill bit.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi D42 Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi D42