Ryobi EHT150V Manuel d'utilisateur télécharger pdf (Page 9)

English

FR DE ES IT NL PT DK SE FI NO RU PL CZ HU RO LV LT EE HR SI SK GR TR

33. Grooved gripping section

34. Live tool indicator

35. Collet sleeve

36. Tool head

SPECIFICATIONS

Input 230 V - 240 V 50 Hz

Rated speed 10,000-35,000 (RPM) min

-1

Collet 3.2 mm max.

Weight 0.73 kg

OPERATION

WARNING

Do not allow familiarity with tools to make you careless.

Remember that a careless fraction of a second is

sufﬁ cient to inﬂ ict serious injury.

WARNING

Always wear eye protection. Failure to do so could

result in objects being thrown into your eyes, resulting

in possible serious injury.

WARNING

Do not use any attachments or accessories not

recommended by the manufacturer of the product. The

use of attachments or accessories not recommended

can result in serious personal injury.

APPLICATIONS

You may use this product for the purposes listed below:

 Cutting

 Sanding

 Polishing and buffing

 Engraving

 Drilling

 Grinding

TURNING THE ROTARY TOOL ON/OFF

See Figure 2.

 To turn the tool on: Slide the switch to “|”.

 To turn the tool off: Slide the switch to “O”.

CAUTION

To prevent damage to the spindle or spindle lock,

always allow motor to come to a complete stop before

engaging the spindle lock.

CHANGING COLLETS

See Figure 3.

 Unplug the tool.

 Press and hold the spindle lock, and rotate the shaft

with the provided collet wrench until the spindle lock

engages the shaft, preventing further rotation.

 With the spindle lock engaged, use the collet wrench

to loosen the collet nut, if necessary.

 Remove the collet nut and old collet using collet

wrench, if necessary.

 Insert the unslotted end of the collet in the hole in the

end of the tool shaft.

 Replace the collet nut on the shaft.

WARNING

Always use the collet which matches the shank size

of the accessory you plan to use. Never force a large

diameter shank into a collet. The accessory should

ﬁ t smoothly into the collet, but you should be able to

tighten the accessory ﬁ rmly and securely with the

provided wrench.

DANGER

If you are changing an accessory immediately after

use, be careful not to touch the collet, collet nut, or

the accessory with your hands or ﬁ ngers. You will

get burned because of the heat build-up from cutting.

Always use the wrench provided.

INSTALLING ACCESSORIES

See Figure 4–5.

 Unplug the tool.

 Press and hold the spindle lock, and rotate the shaft

by hand until the spindle lock engages the shaft,

preventing further rotation.

 With the spindle lock engaged, use the collet wrench

to loosen the collet nut, if necessary.

 Insert the shank of the accessory into the collet until

the shank bottoms out, then pull it out 1.6 mm (1/16 in)

to allow for expansion when the accessory gets hot.

 With the spindle lock engaged, tighten the collet nut

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 254 255

Commentaires sur ces manuels

Pas de commentaire

Ryobi EHT150V Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi EHT150V