Ryobi P523 Manuel d'utilisateur télécharger pdf (Page 8)

8 - English

ANGLE CUTTING (BEVEL CUTTING)

See Figures 11-12, page 11.

Bevel cutting angles may be adjusted from 0° to 45° right

or left. Angles for cuts from 0° to 45° in 15° increments are

marked on a scale on both the left and right side of the base.

Notches on the underside of the base provide positive stops

at each of the above mentioned 15° increments. A protractor

is recommended when accurate cuts are required.

 Remove the battery pack.

 Remove the hex key from the storage compartment.

Loosen the two base pivot screws until the base can be

moved.

NOTE: Do not completely remove screws.

 Slide the base backward until the base can move freely

left and right.

OPERATION

 Align the pointer on the housing with the desired angle

indicated on the scale on the saw base.

 Once the desired angle is reached, slide base forward until

the tab on the motor housing aligns with the appropriate

notch on the underside of the base.

NOTE: When making a set-up for accurate cuts with

a protractor, or for angles other than the preset 15°

increments, the positive stop notches on the underside

of the base are not used.

 Tighten the base pivot screws securely.

 Return the hex key to the storage compartment.

 Replace the battery pack.

ACCESSORIES

Look for these accessories where you purchased this product or call 1-800-525-2579:

Edge Guide Kit .................................................................................................................................................202936001

WARNING:

Current attachments and accessories available for use with this product are listed above. Do not use any attachments

or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not

recommended can result in serious personal injury.

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts could create a hazard or cause

product damage.

MAINTENANCE

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

This product has a Three-year Limited Warranty.

For Warranty details go to www.ryobitools.com

NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 9

AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ryobi P523 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi P523