Ryobi RE180PL1G Manuel de l'opérateur télécharger pdf (Page 13)

13 − English

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts could create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1, along with hearing protection.

Failure to do so could result in objects being thrown into

your eyes and other possible serious injuries.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which could result in serious personal

injury.

Electric tools used on fiberglass material, wallboard, spackling

compounds, or plaster are subject to accelerated wear and

possible premature failure because the fiberglass chips and

grindings are highly abrasive to bearings, brushes, commuta-

tors, etc. Consequently, we do not recommended using this

tool for extended work on these types of materials. However,

if you do work with any of these materials, it is extremely

important to clean the tool using compressed air.

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient

amount of high grade lubricant for the life of the unit under

normal operating conditions. Therefore, no further lubrica-

tion is required.

POWER SUPPLY CORD REPLACEMENT

If replacement of the power supply cord is necessary, this

must be done by an authorized service center in order to

avoid a safety hazard.

CLEANING THE BITS

Get faster more accurate cutting results by keeping

bits clean and sharp. Remove all accumulated pitch and

gum from bits after each use. When sharpening bits, sharpen

only the inside of the cutting edge. Never grind the outside

diameter. When sharpening the end of a bit, be sure to grind

the clearance angle the same as originally ground.

CLEANING THE COLLET

From time to time, it becomes necessary to clean the collet

and collet nut. To do so, simply remove collet nut from collet

and clean the dust and chips that have collected. Then return

collet nut to its original position.

BRUSH ASSEMBLIES

See Figure 21, page 17.

The router has externally accessible brush assemblies that

should periodically be checked for wear.

To replace brushes:

Unplug the router.

Remove brush cap with a screwdriver. Brush assembly

is spring loaded and will pop out when you remove

brush cap.

 Remove brush assembly (brush and spring).

 Check for wear. If worn, always replace in pairs. Do not

replace one side without replacing the other.

 Reassemble using new brush assemblies. Make sure

curvature of brush matches curvature of motor and that

brush moves freely in brush tube.

 Make sure brush cap is oriented correctly (straight) and

replace.

 Tighten brush cap securely. Do not over torque.

NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 15

AFTER FRENCH AND SPANISH LANGUAGE SECTIONS.

This product has a Three-year Limited Warranty.

For Warranty details go to www.ryobitools.com

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi RE180PL1G Manuel de l'opérateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi RE180PL1G