Ryobi RTS30 Manuel de l'opérateur télécharger pdf (Page 41)

41

TROUBLESHOOTING

PROBLEM CAUSE SOLUTION

Adjust positive stops.

Adjust the miter gauge.

Clean the gears or screw post.

Plug in motor cord or wall cord.

Replace circuit fuse.

Reset circuit breaker.

Have the cord or switch replaced at your

nearest authorized service center.

Clean, sharpen, or replace blade.

Replace with correct type.

Remount blade.

Move locking lever to left.

Change blade; rip blade typically has fewer

teeth.

Saw does not make accurate

90˚ or 45˚ cuts.

Height/bevel adjusting hand-

wheel is hard to turn.

Saw does not start.

Blade makes poor cuts.

Blade does not lower when

turning height/bevel adjusting

handwheel.

Motor labors in rip cut.

Positive stops inside cabinet need

adjusting (Bevel Cuts).

Miter gauge is misaligned (Miter

Cuts).

Gears or screw post inside

cabinet are clogged with saw

dust.

Motor cord or wall cord is not

plugged in.

Circuit fuse is blown.

Circuit breaker is tripped.

Cord or switch is damaged.

Blade is dull or dirty.

Blade is wrong type for cut being

made.

Blade is mounted backwards.

Locking lever is not at full left

position.

Blade not proper for rip cut.

1 2 ... 36 37 38 39 40 41 42

Commentaires sur ces manuels

Pas de commentaire