Ryobi TSS102L Manuel d'utilisation et d'entretien télécharger pdf (Page 25)

100

25 − English

OPERATION

 Grasp the stock firmly with one hand and secure it against

the fence. Use the optional work clamp or a C-clamp to

secure the workpiece when possible.

 Before turning on the saw, perform a dry run of the cutting

operation just to make sure that no problems will occur

when the cut is made.

 Grasp the saw handle firmly then squeeze the switch

trigger. Allow several seconds for the blade to reach

maximum speed.

 Slowly lower the blade into and through the workpiece.

 Release the switch trigger and allow the saw blade to stop

rotating before raising the blade out of workpiece. Wait

until the electric brake stops blade from turning before

removing the workpiece from miter table.

TO SUPPORT LONG WORKPIECES

See Figure 33.

Long workpieces need extra supports. Supports should be

placed along the workpiece so it does not sag. The support

should let the workpiece lay flat on the base of the saw and

work table during the cutting operation. Use the optional

work clamp or a C-clamp to secure the workpiece.

WARNING:

Never make a cut by pulling the saw toward you as the

blade can climb on top of the workpiece and come toward

you. Failure to heed this warning could result in serious

personal injury.

TO SLIDE CUT

See Figures 34 - 35.

The sliding feature will cut workpieces 12 in. wide by

1-1/2 in. thick or 3-1/2 in. wide by 3-1/2 in. thick. With the

saw off, pull the saw arm forward. Turn the saw on (let blade

reach maximum speed), push the blade down cutting into the

workpiece then back toward the rear of the saw to make a

cut. Cuts are made by pushing the saw blade away from you

and toward the bevel scale at the back of the saw stopping

when the full rear position has been reached after each cut.

When the saw is running (turned on), NEVER pull the saw

blade toward you or toward the front of the saw.

Raise saw arm to its full height.

Place the workpiece flat on the miter table with one edge

securely against the fence. If the board is warped, place

the convex side against the fence. If the concave edge

of a board is placed against the fence, the board could

collapse on the blade at the end of the cut, jamming the

blade. See Figures 40 - 41.

Fig. 33

LONG

WORKPIECE

WORKPIECE SUPPORTS

SLIDE CUT

SLIDE SAW ARM

FORWARD THEN

PUSH DOWN

Fig. 34

SLIDE LOCK

KNOB

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 99 100

Commentaires sur ces manuels

Pas de commentaire

Ryobi TSS102L Manuel d'utilisation et d'entretien Page 25

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi TSS102L