Ryobi BG828G Manuel d'utilisation et d'entretien télécharger pdf (Page 10)

10 – English

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts could create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which could result in serious personal

injury.

NOTE: FIGURES (ILLUSTRATIONS) START ON PAGE 11 AFTER

FRENCH AND SPANISH LANGUAGE SECTIONS.

This product has a Three-year Limited Warranty.

For Warranty details go to

www.ryobitools.com

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient

amount of high grade lubricant for the life of the unit under

normal operating conditions. Therefore, no further lubrication

is required.

POWER SUPPLY CORD REPLACEMENT

If replacement of the power supply cord is necessary, this

must be done by an authorized service center in order to

avoid a safety hazard.

WHEEL REPLACEMENT

See Figure 15, page 15.

If you must replace a grinding wheel, be sure to obtain one

with a safe rated speed at least as high as the “no load

speed” RPM marked on the data plate of the grinder and

which is marked to comply with ANSI B7.1.

To replace the grinding wheel:

 Unplug the grinder.

 Remove the wheel cover by loosening the screws.

 Loosen the wheel nut in a clockwise direction for the left

side and a counterclockwise direction for the right side.

 Remove the outer flange and grinding wheel.

 To install a new grinding wheel, reverse the above

procedure.

NOTE: Be sure the grinding wheel and outer flange are

properly seated on the spindle shaft.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Ryobi BG828G Manuel d'utilisation et d'entretien Page 10

Commentaires sur ces manuels