Ryobi P420 Manuel de l'opérateur télécharger pdf (Page 14)

POSITIONING THE GUARD

See Figures 7 - 10.

The guard on the grinder should be correctly installed

depending on which side the handle is mounted. Never

use the grinder without the guard correctly in place.

WARNING:

Never place the guard so that it is in front of the grinder

as shown in figure 7. This could result in serious injury

because sparks and loose particles thrown from the

grinding wheel would be directed toward the operator.

Always place the guard in the correct location as

shown.

To adjust the guard:

� Remove battery from the grinder.

� Unlock the guard clasp by pulling the clasp out, away

from the grinder.

� Rotate the guard to its correct position as shown.

NOTE: Be sure the raised ridge on the guard is seated

in the groove on the bearing cap. Never use the grinder

without the guard in place and properly adjusted.

ROTATING FOOT

See Figure 11.

The foot of the grinder can be rotated up to 270° to the left

for easier access to hard to reach areas. Stops are located

at 90°, 180°, and 270°.

Fig. 9

SIDE HANDLE ON LEFT SIDE OF GRINDER

TOOLLESS

GUARD

OPERATION

Fig. 8

TOOLLESS

GUARD

CLASP

Fig. 7

1 2 ... 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Ryobi P420 Manuel de l'opérateur Page 14