Ryobi P310 Manuel d'utilisateur télécharger pdf (Page 14)

14 15

OPERATION

Fig. 8

Fig. 10

WARNING:

Battery tools are always in operating condition. There-

fore, switch should always be locked when not in use or

carrying at your side.

APPLYING CAULK

See Figures 8 - 10.

n �Prepare the surface to be caulked by removing any dust,

dirt, or remnants of old caulking. Make sure the area to

be caulked is clean and dry.

n Set the speed of the caulk gun to match your application

needs, using just enough caulk to do the job. Experiment

in an out-of-the-way area to find the best speed to use

to deliver the caulk bead you want.

n Hold the gun at a slight angle. If filling a crack, insert the

spout into the crack, if possible; otherwise, run the caulk

gun along the surface.

n Squeeze the trigger on the caulk gun, allowing the caulk

to extrude from the tube tip.

NOTE: If the bead of caulk is too narrow, re-cut the nozzle

to provide a larger opening. However, it is better to apply

a thin bead of caulk and add a little more if necessary than

to apply too much and attempt to remove the excess.

n Carefully move the caulk gun at an even pace along the

gap to be filled as you continue to depress the switch

trigger. Make sure the caulk comes in full contact with

both application surfaces. If necessary, use your finger

to gently press the caulk into a corner or crack.

NOTE: The best fill is usually achieved by pushing the

caulk out into the gap in a forward motion. However, in

some cases (particularly where the side materials are

rough or uneven), a pulling motion may work better as

the cartridge will be less likely to get snagged along the

joint.

n The motor will shut off automatically when a caulk tube

becomes empty. Pull the plunger rod back and replace

the caulk tube as necessary.

n �To end the caulk bead, release the switch trigger.

n Draw a moistened finger or other “smoothing tool” along

the caulk bead after applying. This will help the caulk

adhere to the application surfaces and will create a clean,

finished appearance.

n Use a damp towel or rag to clean off any excess caulk.

VARIABLE SPEED

SELECTOR

LOW SPEED

HI SPEED

Fig. 9

CAULK BEAD

1 2 ... 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi P310 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi P310