Ryobi SDS60 Manuel d'utilisateur télécharger pdf (Page 11)

OPERATION

SDS CHUCK

See Figures 4 - 5.

The rotary hammer has an SDS chuck that is used with

SDS bits. A keyless chuck is also supplied with the rotary

hammer. The rotary hammer can be used with just the SDS

chuck or with the supplied keyless chuck installed into the

SDS chuck.

To install chuck and bits into the SDS chuck:

 Unplug the rotary hammer.

 Slide the chuck body down.

 Install the SDS chuck or bit into the chuck.

 Release the chuck body.

Once the keyless chuck has been installed into the SDS

chuck, the keyless chuck can now be used with standard

drill bits.

The keyless chuck makes it simple to tighten or release drill bits

in the chuck jaws. Grasp and hold the collar of the chuck with

one hand. Rotate the chuck body with your other hand. The

arrows on the chuck indicate which direction to rotate the chuck

body in order to GRIP (tighten) or RELEASE the drill bit.

WARNING:

Do not hold the chuck body with one hand and use the

power of the rotary hammer to tighten the chuck jaws

on the drill bit. The chuck body could slip in your hand,

or your hand could slip and come in contact with the

rotating drill bit. This could cause an accident resulting

in serious personal injury.

WARNING:

Always unplug the tool when installing or removing bits,

adjusting settings, or when the tool is not in use. Failure

to unplug the tool may result in accidental starting and

serious personal injury.

INSTALLING BITS IN KEYLESS CHUCK

See Figures 5 - 6.

 Unplug the rotary hammer.

 Open or close the chuck jaws to a point where the opening

is slightly larger than the bit size you intend to use. Also,

raise the front of the rotary hammer slightly to keep the

bit from falling out of the chuck jaws.

 Insert the drill bit.

WARNING:

Make sure to insert the drill bit straight into the chuck

jaws. Do not insert the drill bit into the chuck jaws at

an angle then tighten, as shown in figure 6. This could

cause the drill bit to be thrown from the rotary hammer,

resulting in possible serious personal injury or damage

to the chuck.

 Tighten the chuck jaws securely on the bit.

NOTE: Rotate the chuck body in the direction of the

arrow marked GRIP to close the chuck jaws. Do not use

a wrench to tighten or loosen the chuck jaws.

REMOVING BITS

See Figure 5.

 Unplug the rotary hammer.

 Open the chuck jaws.

NOTE: Rotate the chuck body in the direction of the

arrow marked RELEASE to open the chuck jaws. Do not

use a wrench to tighten or loosen the chuck jaws.

 Remove the drill bit.

Fig. 5

GRIP

RELEASE

KEYLESS

CHUCK

SDS CHUCK

KEYLESS

CHUCK

JAWS

DRILL BIT

Fig. 6

WRONG

RIGHT

SLIDE CHUCK

BODY

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi SDS60 Manuel d'utilisateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi SDS60