Ryobi YN200BNE Manuel d'utilisateur télécharger pdf (Page 12)

12 - English

MAINTENANCE

COLD WEATHER OPERATION

For cold weather operation, near and below freezing, the

moisture in the air line may freeze and prevent tool operation.

We recommend the use of air tool lubricant or permanent

antifreeze (ethylene glycol) as a cold weather lubricant.

CAUTION:

Do not store tools in a cold weather environment to

prevent frost or ice formation on the tools’ operating

valves and mechanisms that could cause tool failure and

personal injury.

NOTE: Some commercial air line drying liquids are harmful

to “O” rings and seals. Do not use these low temperature

air dryers without checking compatibility.

AIR SUPPLY PRESSURE AND VOLUME

Air volume is as important as air pressure. The air volume

supplied to the tool may be inadequate because of undersize

fittings and hoses, or from the effects of dirt and water in the

system. Restricted air flow will prevent the tool from receiving

an adequate volume of air, even though the pressure reading

is high. The results will be a slow operation or reduced

driving power. Before evaluating tool problems for these

symptoms, trace the air supply from the tool to the supply

source for restrictive connectors, low points containing

water and anything else that would prevent full volume flow

of air to the tool.

WARNING:

When servicing use only identical replacement parts.

Use of any other parts may create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked

to comply with ANSI Z87.1 along with hearing and

head protection. Failure to do so could result in objects

being thrown into your eyes and other possible serious

injuries.

WARNING:

Disconnect the tool from the air supply before performing

maintenance. Failure to do so could result in serious

personal injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which may result in serious personal

injury.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi YN200BNE Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi YN200BNE