Ryobi P501 Manuel de l'opérateur télécharger pdf (Page 11)

10 11

ASSEMBLY

ATTACHING THE BLADE

See Figure 2.

WARNING:

A 5-1/2 in. blade is the maximum blade capacity of the

saw. Never use a blade that is too thick to allow outer

blade washer to engage with the flats on the spindle.

Larger blades will come in contact with the blade guard,

while thicker blades will prevent blade screw from se

curing blade on spindle. Either of these situations could

result in a serious accident.

n Remove the battery pack from the saw.

Remove the blade wrench (5 mm hex key) from the stor

age area.

n Depress the spindle lock button and remove the blade

screw and outer blade washer.

NOTE:

Turn the blade screw clockwise to remove.

CAUTION:

To prevent dam

age to the spindle or spindle lock, always

allow motor to come to a complete stop before engaging

spindle lock.

n Wipe a drop of oil onto the inner blade washer and outer

blade washer where they contact the blade.

WARNING:

If inner blade washer has been removed, replace it before

placing blade on spindle. Failure to do so could cause an

accident since blade will not tighten prope

rly.

n Fit the saw blade inside the lower blade guard and onto

the spindle.

NOTE:

The saw teeth point upward at the front of the

saw.

n Replace the outer blade washer.

n Depress the spindle lock button, then replace the blade

screw. Tighten the blade screw securely by turning it

clockwise.

n Return the blade wrench to the storage area.

NOTE: Never use a blade that is too thick to allow the outer

blade washer to engage with the flats on the spindle.

REMOVING THE BLADE

See Figure 3.

n Remove the battery pack from the saw.

n Remove the blade wrench from the storage area.

Fig. 2

INNER

BLADE WASHER

OUTER

BLADE WASHER

LOWER BLADE

GUARD HANDLE

BLADE SCREW

BLADE

SPINDLE

LOCK BUTTON

n Position the saw as shown, depress the spindle lock

button, and remove the blade screw by turning it clock

wise.

n Remove the outer blade washer.

n Remove the blade.

Fig. 3

SPINDLE

LOCK

TO LOOSEN

TO TIGHTEN

LOWER

BLADE

GUARD LEVER

SPINDLE

LOCK

SCREW

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi P501 Manuel de l'opérateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Ryobi P501