Ryobi TC401 Manuel d'utilisation et d'entretien télécharger pdf (Page 9)

9 — English

ASSEMBLY

UNPACKING

This product requires assembly.

 Carefully remove the product and any accessories from

the box. Make sure that all items listed in the packing list

are included.

WARNING:

Items in this Assembly section are not assembled to the

product by the manufacturer and require customer instal-

lation. Use of a product that may have been improperly

assembled could result in serious personal injury.

 If any parts are damaged or missing, please call

1-800-525-2579 for assistance. In Mexico, please call

01-800-843-1111.

WARNING:

If any parts are damaged or missing do not operate

this product until the parts are replaced. Use of this

product with damaged or missing parts could result in

serious personal injury.

WARNING:

Do not attempt to modify this product or create acces-

sories not recommended for use with this product. Any

such alteration or modification is misuse and could result

in a hazardous condition leading to possible serious

personal injury.

WARNING:

Do not connect to power supply until assembly is

complete. Failure to comply could result in accidental

starting and possible serious personal injury.

ATTACHING WATER SUPPLY KIT

See Figure 4, page 15.

The water supply must come from a fresh water main. NEVER

turn the water supply on high. The water supply valve provides

a convenient on/off control lever for starting and stopping

the water flow onto the cutting wheel.

 Unplug the saw.

 Attach the water supply kit to the saw as shown using

the screw provided. Tighten securely.

 With the faucet turned completely off, attach the faucet

adaptor to a garden hose or outdoor faucet.

 Once the cutting wheel is installed, the tile saw is ready

to be used.

NOTE: The tool is rated for a maximum water pressure of

60psi.

NOTE: For dry cutting, it is not necessary to install the water

supply kit.

WARNING:

A 4-3/8 in. (111 mm) wheel is the maximum wheel capac-

ity of the saw. Also, never use a wheel that is too thick to

allow outer cutting wheel washer to engage with the flat

on the spindle. Larger wheels will come in contact with

the wheel guards, while thicker wheels will prevent cutting

wheel screw from securing wheel on spindle. Either of

these situations could result in a serious accident.

WARNING:

Do not use cutting wheels rated less than the no load

speed of this tool. Failure to heed this warning could

result in personal injury. Do not use wheel with cracks,

gaps, or teeth.

WARNING:

Do not use toothed or segmented wheels. Use only

continuous rimmed diamond wheels suited for masonry

materials.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

Commentaires sur ces manuels

Pas de commentaire

Ryobi TC401 Manuel d'utilisation et d'entretien Page 9

Commentaires sur ces manuels