Ryobi ts1341 Manuel d'instructions télécharger pdf (Page 9)

$"# "$#$'$#'

1. Unlock tool mounts and slide saw along table

top surface until it is against the Transport

Stop (see page 8).

8=. For most comfortable transport, saw

should be positioned at the end of the stand

closest to the Transport Wheels. Adjust

Transport Stop, if necessary.

2. Close and lock Extension Rails (see page

12).

8=. Sticker designating lift handle location

affixed to stand end cap. These are your lift

handles and should be used when lifting the

stand for the following procedures.

3. Fold stand legs: Begin at end with installed

Transport Wheels. First, lift stand at

designated lift handle. Push in a leg locking

pin and rotate that leg up until the locking pin

clicks into place. (See page 6) Repeat for

second leg and lower stand down onto

wheels.

4. Repeat same step on opposite side, folding

legs into place.

5. To transport, grip the lift handle and roll to

location on Transport Wheels.

6. To setup stand for use, follow same

instructions above, starting with either side of

stand desired.

-9-

FIG. G FIG. H

BM 2610013406 06-10:BM 2610013406 06-10 6/14/10 9:52 AM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 39 40

Pas de commentaire

Ryobi ts1341 Manuel d'instructions Page 9