Ryobi 770rEB Manuel d'utilisateur télécharger pdf (Page 10)

ASSEMBLY INSTRUCTIONS

Fig. 4

Fig. 5

Fig. 6

INSTALLING THE CUTTING ATTACHMENT

SHIELD

Use the following instructions if the cutting attachment

shield on your unit is not installed.

WARNING: Never operate the trimmer

without the cutting attachment shield in

place to prevent serious personal injury.

1. Slide the cutting attachment shield into the shield

mount on the cutting attachment. Align the screw

holes in the shield with the holes in the cutting

attachment (Fig. 4).

Screws

Shaft Housing

Hex Lock Nut

Cutting Attachment

Shield

Cutting Attachment

2. Place a hex lock nut into one of the three recessed

holes on the top of the cutting attachment shield

(Fig 5).

3. Install a screw into the hole from the bottom of the

cutting attachment shield and screw it into the nut

installed in step #2 (Fig 6). Do not tighten.

4. Repeat steps 2 and 3 until all three screws have

been started, then tighten securely.

Cutting Attachment

Shield

Recessed Holes

Shield Mount

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 27 28

Pas de commentaire

Ryobi 770rEB Manuel d'utilisateur Page 10