Ryobi RY26000 Manuel d'utilisateur télécharger pdf (Page 9)

7 — English

UNPACKING

This product requires assembly.

 Carefully remove the product and any accessories from

the box. Make sure that all items listed in the packing list

are included.

 Inspect the product carefully to make sure no breakage

or damage occurred during shipping.

 Do not discard the packing material until you have care-

fully inspected and satisfactorily operated the product.

 If any parts are damaged or missing, please call

1-800-860-4050 for assistance.

PACKING LIST

Powerhead

Front Handle

Bottle of 2-Cycle Lubricant

Operator’s Manual

WARNING:

If any parts are damaged or missing do not operate this

product until the parts are replaced. Operation of this

product with damaged or missing parts or without an

attachment could result in serious personal injury.

WARNING:

Do not attempt to modify this product or create acces-

sories not recommended for use with this product. Any

such alteration or modification is misuse and could result

in a hazardous condition leading to possible serious

personal injury.

WARNING:

To prevent accidental starting that could cause serious

personal injury, always disconnect the engine spark plug

wire from the spark plug when assembling parts.

INSTALLING AN ATTACHMENT TO THE

POWERHEAD

See Figure 2.

WARNING:

Never install, remove, or adjust any attachment while

powerhead is running. Failure to stop the engine can

cause serious personal injury. Never operate powerhead

without an attachment.

The attachment connects to the powerhead by means of a

coupler device.

 Loosen the knob on the coupler of the powerhead shaft

and remove the hanger cap from the attachment.

ASSEMBLY

 Push in the button located on the attachment shaft. Align

the button with the guide recess on the powerhead coupler

and slide the two shafts together. Rotate the attachment

shaft until the button locks into the positioning hole.

NOTE: If the button does not release completely in the

positioning hole, the shafts are not locked into place.

Slightly rotate from side to side until the button is locked

into place.

 Tighten the knob securely.

WARNING:

Be certain the knob is fully tightened before operating

equipment; check it periodically for tightness during use

to avoid serious personal injury.

REMOVING AN ATTACHMENT FROM THE

POWERHEAD

For removing or changing the attachment:

 Loosen the knob.

 Push in the button and twist the shafts to unlock and

separate.

ATTACHING THE STORAGE HANGER

See Figure 3.

There are two ways to hang your attachment for storage.

To use the hanger cap, push in the button and place the

hanger cap over end of the lower end attachment shaft.

Slightly rotate the cap from side to side until the button

locks into place.

 The secondary hole in the attachment shaft can be used

for hanging purposes as well.

ATTACHING THE FRONT HANDLE

See Figure 4.

 Remove wing nut, washer, and bolt from the front

handle.

 Install the front handle onto the top side of the drive shaft

housing in the area indicated by the label.

NOTE: The open side of the handle should face the

operator.

 Place the bolt through the front handle.

NOTE: The hex bolt head fits inside the hex recess molded

into one side of the handle.

 Reinstall the washer and wing nut.

 Tighten wing nut securely.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 41 42

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY26000 Manuel d'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Ryobi RY26000