Ryobi BE318-2 Manuel d'utilisateur télécharger pdf (Page 10)

OPERATION

SELECTING SANDING BELTS

Selecting the correct size and type of sanding belt is an

important step in achieving a high quality sanded finish. Alu-

minum oxide, silicon carbide, and other synthetic abrasives

are best for power sanding.

In general, when sanding, coarse grit removes the most ma-

terial and fine grit produces the best finish. The condition of

the surface to be sanded determines which grit will do the

best job. If the surface is rough, start with a coarse grit and

sand until the surface is uniform. Then use medium grit to

remove scratches left by the coarser grit. Finally, use finer

grit for finishing the surface. Always continue sanding with

each grit until the surface is uniform.

USING SANDING BELTS

TO INSTALL/CHANGE SANDING BELTS

See Figures 2 - 4.

Follow these steps to install or change sanding belts.

n Unplug the sander.

WARNING:

Failure to unplug the tool could result in serious injury

due to accidental starting.

n Position the sander on its side with the cord on the left.

WARNING:

Keep hands and fingers clear of both rollers and spring

mechanism at all times. Failure to do so could result in

fingers getting pinched, causing serious injury.

n Raise the tension release lever.

NOTE: If you are changing sanding belts, remove the old

sanding belt at this time.

n Install the sanding belt.

CAUTION:

If the sanding belt is not a bidirectional belt, ensure that

the arrow inside the belt is pointing in the direction of the

rotation (clockwise when looking into the open side of the

sander). Installing unidirectional sanding belts backwards

can create a hazardous condition.

n Align the sanding belt to its correct position.

n Lower the tension release lever to secure the sanding

belt.

TENSION RELEASE

LEVER

INSTALL UNIDIRECTIONAL BELTS IN THE DIRECTION OF THE

ROTATION

INSTALL BIDIRECTIONAL BELTS IN EITHER DIRECTION

Fig. 2

Fig. 3

Fig. 4

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi BE318-2 Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à broyer Ryobi BE318-2