Ryobi TS1344L Manuel de l'opérateur télécharger pdf (Page 17)

ASSEMBLY

WARNING:

Make sure the spindle lock button is not engaged

before reconnecting saw into power source. Never engage

spindle lock button when blade is rotating.

NOTE: Many of the illustrations in this manual show only

portions of the compound miter saw. This is intentional so

that we can clearly show points being made in the illustra-

tions. Never operate the saw without all guards securely

in place and in good operating condition.

SQUARING THE SAW BLADE TO THE FENCE

See Figures 15 - 19.

 Unplug the saw.

 Pull the saw arm all the way down and engage the lock

pin to hold the saw arm in transport position.

 Loosen the miter lock handle approximately one-half turn.

 Rotate the miter table until the scale indicator on the

control arm is positioned at 0°.

 Securely tighten the miter lock handle.

 Lay a framing square flat on the miter table. Place one

leg of the square against the fence. Slide the other leg

of the square against the flat part of saw blade.

NOTE: Make sure that the square contacts the flat part

of the saw blade, not the blade teeth.

 The edge of the square and the saw blade should be

parallel as shown in figure 16.

 If the front or back edge of the saw blade angles away

from the square as shown in figures 17 and 18, adjust-

ments are needed.

 Loosen the socket head screws that secure the miter

fence to the saw base.

 Rotate the miter fence left or right until the saw blade is

parallel with the square.

 Retighten the screws securely and recheck the blade-to-

fence alignment.

The saw has two scale indicators, one on the bevel scale

and one on the miter scale. After squaring adjustments have

been made, it may be necessary to loosen the indicator

screws and reset them to zero.

Fig. 15

FENCE

SOCKET HEAD

SCREW(S)

Fig. 16

VIEW OF BLADE SQUARE WITH FENCE

MITER

LOCK HANDLE

MITER

TABLE

BLADE

FRAMING

SQUARE

MITER

FENCE

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Commentaires sur ces manuels

Pas de commentaire

Ryobi TS1344L Manuel de l'opérateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à onglets Ryobi TS1344L