Ryobi AP13AK Spécifications télécharger pdf (Page 10)

ADJUSTMENT

Page 9

NOTE: Remove gauge block before starting machine.

Thickness planing is the sizing of the material to a

desired thickness, while creating a smooth surface

parallel to the opposite side of the board.

The art of thickness planing consists mainly of using

good judgement about the depth of cut in various

situations. You must take into account:

1) The width of the timber

2) The hardness of the board

3) The dampness of the board

4) The straightness of the board

5) The grain direction

6) The grain structure

How these factors can effect the quality of the work

can only be learned through experience. Whenever

working with a new type of wood, or one with unusual

problems, always make test cuts on scrap material

prior to working on the actual piece.

FOR ADDITIONAL PLANING

If additional planing is needed to obtain the desired

thickness or nish, hand crank the cutterhead no more

than 3mm (at any one time) and complete another

pass.

INSTALLING THE DUST CHUTE

Currently, the planer is assembled with a steel

cover , which is xed by 2 wing nuts (Fig. 13 & 13a)

WARNING:

Never plane more than 3mm in one pass and

never attempt to plane a board under 127mm

(5”) in length. Always wear a protective face

shield.

To install the dust chute , remove the steel cover

rst by unscrewing the 2 wing nuts.

Fix the dust chute with 4 philip screws (Fig 13b)

Wing Nuts

Fig. 13

Fig. 13a

Fig. 13b

Wing Nuts

Screws

Steel Cover

Dust Chute

1 2 ... 5 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

Ryobi AP13AK Spécifications Page 10

Commentaires sur ces manuels