Ryobi RS281VS Manuel de l'opérateur télécharger pdf (Page 13)

OPERATING THE SANDER

See Figures 9 - 10.

 Secure the work to prevent it from moving under the

sander.

WARNING:

Unsecured work could be thrown towards the operator

causing injury.

 Place the sander on the workpiece so that all of the sand-

ing disc surface is in contact with the workpiece.

CAUTION:

Be careful not to let your hand cover the air vents.



Start the sander and move it slowly over the workpiece.

 Make successive passes in parallel lines, circles, or

crosswise movements.

NOTE: The front edge of the sander allows for flush

sanding.

 Turn the sander off and wait until the sanding disc

comes to a complete stop before removing it from the

workpiece.

WARNING:

Before connecting the sander to power supply source,

always check to be sure the switch is not in the ON

position. Failure to do so could result in accidental starting

of the sander resulting in possible serious injury.

Do not press down on the sander. The weight of the unit

supplies adequate pressure, so let the sanding disc and

sander do the work. Applying additional pressure only slows

the motor, rapidly wears sanding disc, and greatly reduces

sander speed. Excessive pressure will overload the motor

causing possible damage from motor overheating and can

result in inferior work. Any finish or resin on wood may soften

from the frictional heat. Do not allow sanding on one spot

too long as the sander’s rapid action may remove too much

material, making the surface uneven.

Extended periods of sanding may tend to overheat the motor.

If this occurs, turn sander off and wait until sanding disc

comes to a complete stop, then remove it from workpiece.

Remove the hand from vent area, remove sanding disc, then

with the hand removed from vent area, turn sander on and

run it free without a load to cool motor.

Fig. 9

Fig. 10

OPERATION

1 2 ... 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi RS281VS Manuel de l'opérateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Ponceuses électriques Ryobi RS281VS