Ryobi SP450 Manuel d'utilisation et d'entretien télécharger pdf (Page 10)

10 – English

MAINTENANCE

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts can create a hazard or cause

product damage.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which could result in serious personal

injury.

Electric tools used on fiberglass material, wallboard, spack-

ling compounds, or plaster are subject to accelerated wear

and possible premature failure because the fiberglass chips

and grindings are highly abrasive to bearings, brushes,

commutators, etc. Consequently, we do not recommended

using this tool for extended work on these types of materi-

als. However, if you do work with any of these materials, it is

extremely important to clean the tool using compressed air.

LUBRICATION

All of the bearings in this tool are lubricated with a sufficient

amount of high grade lubricant for the life of the unit under

normal operating conditions. Therefore, no further lubrica-

tion is required.

POWER SUPPLY CORD REPLACEMENT

If replacement of the power supply cord is necessary, this

must be done by an authorized service center in order to

avoid a safety hazard.

OPERATION

SANDING DISC SELECTION

Selecting the correct size grit and type sanding disc is

an extremely important step in achieving a high qual-

ity sanded finish. Aluminum oxide, silicon carbide, and

other synthetic abrasives are best for power sanding.

Natural abrasives such as flint and garnet are too soft for

economical use in power sanding.

In general, coarse grit will remove the most material

and finer grit will produce the best finish in all sanding

operations. The condition of the surface to be sanded will

determine which grit will do the job. If the surface is rough,

start with a coarse grit and sand until the surface is uniform.

Medium grit may then be used to remove scratches left by

the coarser grit and finer grit used for finishing the surface.

Always use the proper grit sanding disc, and not extra pres-

sure when sanding. Continue sanding with each grit until

surface is uniform.

NOTE: ILLUSTRATIONS START ON PAGE 11 AFTER

FRENCH AND SPANISH LANGUAGE SECTIONS.

This product has a Three-year Limited Warranty.

For Warranty details go to www.ryobitools.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi SP450 Manuel d'utilisation et d'entretien Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Ponceuses électriques Ryobi SP450