Ryobi A18MS01 Manuel d'utilisateur télécharger pdf (Page 7)

6 7

Fig. 6

MITER SAW

SAW MOUNTING

BRACKET

CARRIAGE BOLT

FLAT WASHER

NUT

n Install carriage bolts as previously described.

n After making sure both brackets are parallel to each other,

finger tighten all four nuts to hold in position.

If the saw has holes that do not line up with the slots in

the saw mounting brackets:

n Unplug the saw and lock saw arm in the down position.

SLOT

2 x 4

ASSEMBLY

n Mount the saw to a mounting surface at least 1/2 in.

thick using 5/16 hex head screws, washers, and nuts

(not included).

n Drill holes in the mounting surface to match the slots in

the saw mounting brackets.

n Proceed with installation as previously described.

MITER SAW

SAW MOUNTING

BRACKET

SLOT

CARRIAGE BOLT

NUT

MOUNTING

SURFACE

Fig. 7

LOCK WASHER

NUT

FLAT WASHER

LOCK WASHER

FLAT WASHER

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Ryobi A18MS01 Manuel d'utilisateur Page 7