Ryobi TS1141 Manuel d'utilisateur télécharger pdf (Page 20)

ASSEMBLY

SQUARING THE BLADE TO THE FENCE

See Figures 21 - 24.

 Unplug the saw.

 Pull the saw arm all the way down and engage the lock

pin to hold the saw arm in transport position.

 Lift the miter lock lever.

 Rotate the miter table until the pointer aligns with zero

on the miter scale.

 Push the miter lock lever down to lock the miter table.

 Lay a square flat on the miter table. Place one leg of the

square against the fence. Slide the other leg of the square

against the flat part of saw blade.

NOTE: Make sure that the square contacts the flat part

of the saw blade, not the blade teeth.

 The edge of the square and the saw blade should be

parallel as shown in figure 20.

 If the front or back edge of the saw blade angles away

from the square as shown in figures 23 and 24, adjust-

ments are needed.

 Using the blade wrench, loosen the socket head screws

that secure the miter fence to the miter table. See figure

21.

 Rotate the miter fence left or right until the saw blade is

parallel with the square.

 Retighten the screws securely and recheck the blade-to-

fence alignment.

The saw has two scale indicators, one on the bevel scale

and one on the miter scale. After squaring adjustments have

been made, it may be necessary to loosen the indicator

screws and reset them to zero.

Miter

Lock

Lever

Fig. 22

Miter

tabLe

view of bLade square with fence

square

view of bLade not square with fence, adJustMents

are required

Fig. 23

Fig. 21

Miter

fence

socket head

screw(s)

socket head

screw(s)

Fig. 24

view of bLade not square with fence, adJustMents

are required

Miter

fence

bLade

Miter

tabLe

square

Miter

fence

bLade

Miter

tabLe

square

Miter

fence

bLade

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi TS1141 Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi TS1141