Ryobi TS1141 Manuel d'utilisateur télécharger pdf (Page 30)

ADJUSTMENTS

DANGER:

Laser radiation. Avoid direct eye contact with light

source.

WARNING:

Use of controls or adjustments or performance of pro-

cedures other than those specified herein may result in

hazardous radiation exposure.

TO ADJUST THE LASER GUIDE

See Figure 40.

 Use the work clamp or a C-clamp to secure a piece of

scrap wood.

 Plug the saw into the power source and make a slight cut

to score the wood.

 Release the switch trigger and allow the saw blade to

stop rotating before raising the blade.

 Raise the saw arm.

 Unplug the saw.

 To adjust the laser, loosen the laser adjustment screw

using the Phillips end of the supplied blade wrench.

NOTE: When properly aligned, the laser should be on the

left edge of the kerf.

 Once aligned, tighten the screw then remove the blade

wrench.

TO ADJUST THE MITER LOCK LEVER

See Figure 41.

Prior to squaring the saw blade to the fence, check and

adjust the miter lock lever, if needed. In the “locked” posi-

tion, the action of pushing the miter lock lever fully down

should feel tight and secure. Considerable effort should be

required to move the miter table. If the table moves easily

when in the “locked” position, an adjustment of the miter

lock lever is required.

To adjust:

 Unplug the saw.

 Push the miter lock lever fully down to lock.

 Pull the miter lock lever out to the right to disengage, then

pull forward to adjust.

 Release miter lock lever to re-engage

 Recheck the miter table to ensure proper tightness.

Fig. 40

Fig. 41

Lock

unLock

Miter

Lock

Lever

Laser adJustMent

screw

1 2 ... 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi TS1141 Manuel d'utilisateur Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ryobi TS1141