Ryobi HP24 Manuel du propriétaire télécharger pdf (Page 16)

Handle Crank Cross Feed Adjustable Rock Cut Index Control

To use the crank cross feed index wheel, simply clamp and

secure the cutting material into the vise by using the clamp

screw to tighten the vise and turn the wheel crank until the

desired slab thickness is achieved You can measure the

slab thickness with a ruler prior to cutting, but remember,

depending on blade thickness, the amount of waste material

from the rock specimen will vary. Always allow the rock cut

to go to completion before opening the hood of the saw. Do

not over crank the vise to the far left or right position on the

carriage.

Cross feed index, crank the handle

and clutch lever assembly

Clutch lever in disengaged position

Clutch lever in engaged position

Clutch Adjustment

The clutch system is comprised of a lever to cam assembly that raises and lowers a bronze clutch

shoe. Should the clutch not fully engage and move the carriage, loosen the countersink screw below

the vise table inside of the carriage and tighten the two allen head screws to depress the bronze pres-

sure block. Adjust set screws in one-half turn increments. Be sure to retighten countersink screw after

each adjustment. Re-engage the clutch and restart saw to check if feed is working properly. If not,

readjust set screws another 1/2 turn, retighten countersink screw and restart saw to check feed.

HP18 & HP24 STARTUP & ADJUSTMENT

Automatic Feed Engagement/Disengagement System

Highland Precision slab saws are designed for operation with an adjustable clamping vise and self-

feeding carriage mount. The clutch engagement/disengagement lever should be positioned in the

straight upward (12 o'clock) position to disengage the clutch and allow the carriage to move freely

along the rails. To engage the clutch, simply turn the lever in the downward (3 or 9 o'clock) position to

securely engage the bronze shoe and block with the stainless steel thread. Should the carriage not

move freely on the rails, clean the rails with a clean rag and place a liberal amount of wheel bearing

grease on all surfaces of the steel rails to assist in the free movement of the carriage.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Pas de commentaire

Ryobi HP24 Manuel du propriétaire Page 16