Ryobi HP24 Manuel du propriétaire télécharger pdf (Page 5)

DIRECTION OF FEED

Always feed work into a blade or cutter in the direction shown in this manual. All blades, grinding

wheels or polishing belts should always be installed such that rotation is in the direction of the arrow

imprinted on the blade, wheel or belt.

ONLY OPERATE AT THE PROPER SPEED

Severe personal injury and damage to the motor or equipment can result if operated at speeds above

maximum.

NEVER LEAVE A TOOL RUNNING UNATTENDED – TURN POWER OFF

Do not leave a tool until it comes to a complete stop. Always turn the tool off, and disconnect the

power cord to its source, when leaving the work area or when work is finished. Do not leave extension

cords attached to the power cord or power receptacle (wall outlet) when leaving the work area.

CHECK FOR DAMAGED OR WORN PARTS

Before using a power tool, check for damaged parts. A guard or any other part that is damaged

should be carefully checked to determine if it would operate properly and perform its intended

function. Always check moving parts for proper alignment or binding. Check for broken parts and

mountings and all other conditions that may affect the operation of the power tool. A guard, or any

damaged part, should be properly repaired or replaced.

USE RECOMMENDED ACCESSORIES AND PARTS

Consult the owner’s manual for recommended accessories and parts. Using improper parts and

accessories may increase the risk of personal and/or bystander injury.

USE THE PROPER EXTENSION CORD

If using an extension cord, make sure it is in good condition first. When using an extension cord, be

sure to use one heavy enough to carry the current your product will draw. An undersized cord will

cause a drop in line voltage that will result in a loss of power and overheating. The table on page 8

shows the correct AWG (American Wire Gauge) size to use depending on cord length and nameplate

ampere rating. If in doubt, use the next heavier gauge. The smaller the gauge number, the heavier the

cord.

USE THE PROPER POWER SOURCE

This tool is only to be used with a 120 volt 60 HZ power source. Ensure power source is at least 15

amps and 110 to 120 volts. Low voltage current can adversely effect electric motor performance and

overall life.

USE THE RECOMMENDED COOLING AND LUBRICATING FLUIDS

Never operate a tool dry that requires coolant or lubricant. This can lead to shortened tool life, tool

damage and personal injury.

MAINTAIN TOOLS WITH CARE

Keep the diamond blade sharp, the sawing lubricant clean and reservoir filled to the correct level

for the best and safest performance. Always follow the maintenance instructions for sharpening the

blade, lubricating and servicing the Highland Precision Slab Saw.

HP18 & HP24 SAFETY

1 2 3 4 5 6 7 8 9 10 ... 39 40

Pas de commentaire

Ryobi HP24 Manuel du propriétaire Page 5