Ryobi HPL50 Manuel de l'opérateur télécharger pdf (Page 12)

EDGE PLANING

See Figures 10 and 11.

Your planer comes with an adjustable edge guide for

precision edge planing. It can be attached to either side

of your planer and is useful when planing long and un-

even surface boards.

ATTACHING THE EDGE GUIDE

Assemble the edge guide and edge guide bracket using

the carriage head screw, washer and retaining knob.

Attach the edge guide assembly to the desired side of

the planer, ensuring the locating tab on the edge guide

bracket fits into the locating tab hole. Install thumb screw

and tighten securely.

To adjust the edge guide to the width of cut, loosen the

retaining knob and adjust to the desired position. Re-

tighten the retaining knob securely.

Fig. 10

RETAINING

KNOB

CARRIAGE

SCREW

WASHER

EDGE

GUIDE

EDGE GUIDE

BRACKET

Fig. 11

RETAINING

KNOB

LOCATING

TAB HOLE

CARRIAGE

SCREW

WASHER

EDGE

GUIDE

EDGE GUIDE

BRACKET

When making cuts using your edge guide, the guide

should be held firmly against the edge of the board.

See

Figure 12.

OPERATION

THUMB

SCREW

THUMB

SCREW

Fig. 12

RABBET CUTS

See Figure 13.

Rabbet cuts can be made using your planer. The edge

guide attaches to the operator’s right side of the planer

and can be used to make rabbet cuts. The maximum depth

of the rabbet cut is 8 mm (5/16 in.) and has to be cut in

2 mm (5/64 in.) passes, or less, to get the desired depth.

The width of the rabbet cut is adjustable by moving the

edge guide.

LOCATING

TAB HOLE

Fig. 13

RIGHT SIDE MOUNT

LEFT SIDE MOUNT

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18

Commentaires sur ces manuels

Pas de commentaire

Ryobi HPL50 Manuel de l'opérateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi HPL50