Ryobi P515 Manuel de l'opérateur télécharger pdf (Page 12)

CHARGING A HOT BATTERY PACK

When using the tool continuously, the batteries in the battery

pack will become hot. You should let a hot battery pack cool

down for approximately 30 minutes before attempting to

recharge. When the battery pack becomes discharged and

is hot, this will cause the green LED to come on instead of

the red LED. After 30 minutes, reinsert the battery pack in

the charger. If the green LED continues to remain on, return

battery pack to your nearest Ryobi Authorized Service Center

for checking or replacing.

NOTE: This situation only occurs when continuous use of

the tool causes the batteries to become hot. It does not

occur under normal circumstances. Refer to “CHARGING

A COOL BATTERY PACK” for normal recharging of batter-

ies. If the charger does not charge your battery pack under

normal circumstances, return both the battery pack and

charger to your nearest Ryobi Authorized Service Center

for electrical check.

TO REMOVE / ATTACH BATTERY PACK

See Figure 5.

To remove:

n Locate latches on side of battery pack and depress both

sides to release battery pack from your saw.

n Remove battery pack from your saw.

To attach:

n Place the battery pack in your saw aligning raised rib on

battery pack with groove in saw's battery port.

n Make sure the latches on each side of the battery pack

snap into place and battery pack is secured to saw before

beginning operation.

OPERATION

Fig. 3

P110

CHARGER

GREEN LED

YELLOW LED

RED LED

Fig. 4

BATTERY

PACK

P110

CHARGER

BATTERY PACK SHOWN ATTACHED TO CHARGER

Fig. 5

BATTERY

PACK

DEPRESS LATCHES

TO RELEASE

BATTERY PACK

BATTERY PORT

LATCH

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Ryobi P515 Manuel de l'opérateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques Ryobi P515