Ryobi RE1802M Manuel d'utilisateur télécharger pdf (Page 10)

LOCKING

ARM

DEPTH

ADJUSTMENT

RING

OPERATION

WARNING:

Never connect the router to power supply when you

are assembling parts, making adjustments, installing

or removing cutters, or when not in use. Disconnect-

ing the router prevents accidental starting that could

cause serious injury.

REMOVING AND INSTALLING THE ROUTER BASE

TO SWITCH FROM THE FIXED BASE OR D-HANDLE

BASE TO THE PLUNGE BASE

See Figure 4.

TO REMOVE THE FIXED OR D-HANDLE BASE:

1. Unplug the router.

WARNING:

Failure to unplug the tool could result in accidental

starting causing serious injury.

2. Place the router upside down with the Ryobi label

away from you.

3. Loosen the locking arm on the base.

4. Depress and hold the gold spindle lock button. The

gold spindle lock button will not depress fully unless it

is in line with the hole in the collet.

5. If the gold spindle lock button does not depress fully, turn the

collet nut while depressing the gold spindle lock button. As

they align, the gold spindle lock button will depress fully.

6. Turn the depth adjusting ring counterclockwise until

the motor is to its highest position. NOTE: As the motor

is rising, the gold spindle lock button has to be de-

pressed until it clears the rear window.

7. Align the indicator arrow on the depth adjustment ring

with the indicator point on the base.

8. Pull the base until it dislodges from the motor housing.

TO INSTALL THE PLUNGE BASE

1. Unplug the router.

2. Place the plunge base on a flat surface.

3. Loosen the locking knob.

4. Align the groove in the motor housing with the rib

inside the base. NOTE: The rib is located on the inside

of the base in line with the handle.

5. Depress and hold the gold spindle lock button.

6. Slide the motor housing into the base.

7. Tighten the locking knob.

CAUTION:

Do not tighten the locking knob without the motor in-

stalled in the base. Failure to heed this caution may

result in permanent damage to the locking mechanism.

Fig. 4

GOLD

SPINDLE

LOCK

BUTTON

Fig. 5

RIB INSIDE THE BASE

GROOVE IN

MOTOR

HOUSING

15/32

1/32

INDICATOR

POINT

INDICATOR

ARROW

DEPTH

ADJUSTMENT

RING

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi RE1802M Manuel d'utilisateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Routeurs Ryobi RE1802M