Ryobi P300 Manuel de l'opérateur télécharger pdf (Page 13)

OPERATION

Fig. 9

SETTING DEPTH

See Figure 8.

n Rotate the depth adjustment knob clockwise to use more

force for nailing or stapling.

n Rotate depth adjustment knob counter clockwise to use

less force for nailing or stapling.

n Test on a scrap piece of the same material you are using

to achieve the desired results.

NOTE: Harder materials will require more force to nail or

staple.

NAILING OR STAPLING

See Figure 9.

n Hold handle firmly with magazine flat to workpiece

forming a 90º angle.

n Press the activation foot of the nailer/stapler down

against the workpiece to disengage the safety interlock.

The activation foot must be depressed before the switch

trigger is depressed.

n Release the switch trigger and activation foot before

driving another brad or staple.

NOTE: You must release the activation foot and switch

trigger after each brad or staple to reset the tool. The tool

will not fire another staple or brad until the activation foot

and switch trigger are released.

REMOVING A JAMMED BRAD/STAPLE

n Remove battery pack from the tool.

n Hold tool upside down; squeeze latch and slide base

open.

n Remove unused brads/staples from magazine.

n Remove jammed brad/staple with needle nose pliers.

NOTE: You must remove jammed brad/staple before

using tool any further. If you try to fire a brad/staple

while the tool is jammed, you could cause damage to

the mechanism.

Fig. 8

INCREASE

FORCE

DECREASE

FORCE

1 2 ... 8 9 10 11 12 13 14 15 16

Pas de commentaire

Ryobi P300 Manuel de l'opérateur Page 13