Ryobi P300 Manuel de l'opérateur télécharger pdf (Page 12)

OPERATION

Fig. 6

STAPLES

Fig. 5

LATCH

LOADING THE TOOL WITH STAPLES

See Figures 5 and 6.

n Remove battery pack from the tool.

n Hold tool upside down; squeeze latch and slide base

open.

n Place staples in channel, legs facing upward and close

base.

n Make sure the latch is securely locked in place.

n Reattach battery pack to tool.

LOADING THE TOOL WITH BRADS

See Figures 5 and 7.

n Remove battery pack from the tool.

n Hold tool upside down; squeeze latch and slide base

open.

n Place brads in the center of the channel with "T" head

sitting on the slot base. Close base while making sure

brad strip stays upright in channel.

NOTE: There are two channels for the brads. Use the

smaller channel for brads sized 3/4 in. to 1 in. Use the

larger channel for brads sized 1-1/4 in. Refer to molding

on the tool.

n Make sure that the latch is securely locked in place.

n Reattach battery pack to tool.

BRADS

Fig. 7

3/4 IN. TO 1 IN.

1-1/4 IN.

1 2 ... 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Ryobi P300 Manuel de l'opérateur Page 12