Ryobi AG402 Manuel d'utilisateur télécharger pdf (Page 8)

8 - English

WARNING:

The side handle must always be used to help prevent

loss of control and possible serious injury.

INSTALLING THE SIDE HANDLE

See Figure 2, page 11.

 Unplug the angle grinder.

 Insert the side handle into the desired operating

position.

Securely tighten by turning the side handle clockwise.

NOTE: You can install the handle on the left or right side of

the grinder depending on operator preference.

WARNING:

Do not allow familiarity with tools to make you care-

less. Remember that a careless fraction of a second is

sufficient to inflict serious injury.

WARNING:

Always wear eye protection with side shields marked to

comply with ANSI Z87.1. Failure to do so could result in

objects being thrown into your eyes resulting in possible

serious injury.

WARNING:

Do not use any attachments or accessories not

recommended by the manufacturer of this tool. The use

of attachments or accessories not recommended can

result in serious personal injury.

APPLICATIONS

You may use this tool for the purposes listed below:

Grinding metals

Sanding wood or metal surfaces

OPERATION

WARNING:

Do not connect to power supply until assembly is

complete. Failure to comply could result in accidental

starting and possible serious personal injury.

WARNING:

Thoroughly inspect a new grinding wheel before you

install it on the grinder.

•Taplightlyaroundthewheelusingawoodenhammer.

•Listencarefullytotheresultingsounds.Placeswithfis-

sures or cracks will result in a different sound.

Do not use a wheel containing fissures or cracks.

When you install a new grinding wheel, carry out a no

load revolution test of approximately one minute with

the grinding wheel facing a safe direction, i.e., away from

people or objects.

ASSEMBLY

SLIDE SWITCH

See Figure 3, page 11.

To turn the angle grinder ON, press the slide switch for-

ward. To the lock the grinder in the ON position, depress

front of switch. To turn it OFF, depress and slide switch

backward.

CAUTION:

Never cover air vents. They must always be open for

proper motor cooling.

INSTALLING ACCESSORY WHEELS

See Figure 4, page 11.

 Unplug the angle grinder.

 Depress and hold the spindle lock button and rotate nut

with provided wrench until spindle locks.

NOTE: To prevent damage to the spindle or spindle lock,

always allow motor to come to a complete stop before

engaging spindle lock.

 Loosen and remove flange nut from spindle. Do not

remove disc flange.

 Make sure flats on the bottom of disc flange are engaged

with flats on spindle.

 Place the accessory wheel over the spindle.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi AG402 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Outils Ryobi AG402