Ryobi RY80940 Manuel d'utilisateur télécharger pdf (Page 13)

9 — English

ASSEMBLY

CONNECTING HIGH PRESSURE HOSE TO

TRIGGER HANDLE

See Figure 7.

 Screw the collar on the high pressure hose into the trigger

handle inlet coupler by turning the hose collar clockwise.

Tighten securely.

NOTE: Be careful to avoid cross-threading, which can

cause the trigger handle to leak during use.

 Pull on the hose to be certain it is properly secured.

CONNECTING THE HIGH PRESSURE HOSE TO

THE PUMP

See Figure 8.

 Completely uncoil and straighten the high pressure hose

to prevent kinks.

NOTE: See Using The High Pressure Hose in Operation

for more information about using the high pressure hose.

 Align the collar on the threaded nipple on the pump.

 Insert the nozzle on the end of the high pressure hose

collar into the threaded nipple.

 Turn the collar clockwise to tighten the hose securely to

the pump.

NOTE: Be careful to avoid cross-threading, which can

cause the hose to leak during use.

 Pull on the hose to be certain it is properly secured.

CONNECTING THE GARDEN HOSE TO THE

PRESSURE WASHER

See Figure 9.

NOTICE:

Always observe all local regulations when connnecting

hoses to the water main. Some areas have restrictions

against connecting directly to public drinking water

supply to prevent the feedback of chemicals into the

drinking water supply. Direct connection through a

receiver tank or backflow preventer is usually permitted.

The water supply must come from a water main. NEVER use

hot water or water from pools, lakes, etc. Before connecting

the garden hose to the pressure washer:

 Run water through the hose for 30 seconds to clean any

debris from the hose.

 Inspect the screen in the water intake.

 If the screen is damaged, do not use the machine until

the screen has been replaced.

 If the screen is dirty, clean it before connecting the garden

hose to the machine.

To connect the garden hose to the machine:

 Completely uncoil the garden hose or remove completely

from reel to prevent kinks.

NOTE: There must be a minimum of 10 feet of unrestricted

hose between the pressure washer intake and the hose

faucet or shut off valve (such as a “Y” shut off connector).

 With the hose faucet turned completely off, attach the

end of the garden hose to the water intake. Tighten by

hand.

NOTICE:

Do not run the pressure washer pump without water

supply connected and turned on, as this may damage the

high pressure seals and decrease pump life. Completely

unwind the hose from its reel or coil and make sure the

hose is not being restricted by tires, rocks, or any other

objects that may lessen or prevent water flow to the

pressure washer.

DO NOT OVERTILT THE UNIT!

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY80940 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Carwash Ryobi RY80940