Ryobi CSB133L Manuel de l'opérateur télécharger pdf (Page 11)

ASSEMBLY

ATTACHING BLADE

See Figures 2 - 4.

 Unplug the saw.

 Depress and hold spindle lock button.

 Remove blade screw by turning it counterclockwise with

the blade wrench, while keeping the spindle lock button

depressed.

 Remove spring washer and outer blade washer (“D”

washer).

 Wipe a drop of oil onto the inner flange bushing and outer

blade washer (“D” washer) where they contact blade.

WARNING:

If inner flange bushing has been removed, replace it be-

fore placing blade on spindle. Failure to do so will prevent

blade from tightening properly and could result in serious

personal injury.

 Retract the lower blade guard into the upper blade guard

using the lower blade guard handle. Make sure the lower

guard spring works properly, allowing the guard to move

freely.

 Check to see that the saw teeth and arrow on the saw

blade and the arrow on the upper guard are pointing in

the same direction.

NOTE: The saw teeth point upward at the front of the saw

as shown.

 Fit the saw blade inside the lower blade guard and onto

the spindle.

 Replace “D” washer.

 Replace spring washer with cupped side against “D”

washer.

 Depress spindle lock button and replace blade screw.

 Tighten blade screw securely by turning it clockwise with

the blade wrench.

NOTE: Never use a blade that is too thick to allow the

“D” washer to engage with the flat on the spindle.

REMOVING BLADE

See Figures 2 - 4.

Unplug the saw.

Depress and hold spindle lock button.

Remove blade screw by turning it counterclockwise with

the blade wrench, while keeping the spindle lock button

depressed.

Remove spring washer and outer blade washer (“D”

washer).

Lift lower blade guard.

Remove blade.

BLaDe

Fig. 2

Fig. 4

OUTer BLaDe waSHer

(“D” waSHer)

CUPPeD SIDe Of

SPrING waSHer

OUTSIDe Of

SPrING waSHer

INNer

fLaNGe BUSHING

OUTer BLaDe

waSHer

(“D” waSHer)

BLaDe

SCrew

SPrING

waSHer

SPINDLe

BLaDe

GUarD

HaNDLe

Fig. 3

SPINDLe

LOCK BUTTON

BLaDe

wreNCH

LOOSeN

TIGHTeN

arrOw ON

UPPer GUarD

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB133L Manuel de l'opérateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Ryobi CSB133L