Ryobi CSB133L Manuel de l'opérateur télécharger pdf (Page 23)

MAINTENANCE

Electric tools used on fiberglass material, wallboard, spack-

ling compounds, or plaster are subject to accelerated wear

and possible premature failure because the fiberglass chips

and grindings are highly abrasive to bearings, brushes,

commutators, etc. Consequently, we do not recommend

using this product for extended work on these types

of materials. However, if you do work with any of these

materials, it is extremely important to clean the product

using compressed air.

LUBRICATION

All of the bearings in this product are lubricated with a

sufficient amount of high grade lubricant for the life of the

unit under normal operating conditions. Therefore, no further

lubrication is required.

POWER SUPPLY CORD REPLACEMENT

If replacement of the power supply cord is necessary, this

has to be done by the manufacturer or his agent in order to

avoid a safety hazard.

WARNING:

When servicing, use only identical replacement parts.

Use of any other parts may create a hazard or cause

product damage.

WARNING:

Always wear safety goggles or safety glasses with side

shields during power tool operation or when blowing

dust. If operation is dusty, also wear a dust mask.

GENERAL MAINTENANCE

Avoid using solvents when cleaning plastic parts. Most

plastics are susceptible to damage from various types of

commercial solvents and may be damaged by their use. Use

clean cloths to remove dirt, dust, oil, grease, etc.

WARNING:

Do not at any time let brake fluids, gasoline, petroleum-

based products, penetrating oils, etc., come in contact

with plastic parts. Chemicals can damage, weaken or

destroy plastic which may result in serious personal

injury.

ACCESSORIES

Look for these accessories where you purchased this product or call 1-800-525-2579:

 Edge Guide ...................................................................................................................................................... 969862009

 Dust Nozzle Kit ................................................................................................................................................200673001

 7-1/4 in. Thin Kerf Blade

WARNING: