Ryobi CSB141LZ Manuel de l'opérateur télécharger pdf (Page 15)

14 15

STARTING/STOPPING THE SAW

See Figure 11.

To start the saw: Depress the switch trigger.

Always let the blade reach full speed, then guide the saw

into the workpiece.

WARNING:

The blade coming in contact with the workpiece before

it reaches full speed could cause the saw to “kickback”

towards you resulting in serious injury.

To stop the saw: Release the switch trigger.

After you release the switch trigger, allow the blade to

come to a complete stop. DO NOT remove the saw from

the workpiece while the blade is moving.

WARNING:

Failure to unplug the tool could result in accidental start-

ing causing serious injury.

ADJUSTING BLADE DEPTH

See Figure 12.

Always keep correct blade depth setting. The correct blade

depth setting for all cuts should not exceed 1/4 in. below

the material being cut. More blade depth will increase the

chance of kickback and cause the cut to be rough. For more

depth of cut accuracy, a scale is located on the upper blade

guard.

To adjust the blade depth:

n Unplug the saw.

n Loosen depth adjustment knob.

n Determine the desired depth of cut.

n Locate depth of cut scale on back of upper blade

guard.

n Hold base flat against the workpiece and raise or lower

saw until the indicator mark on bracket aligns with notch

on blade guard.

n Tighten depth adjustment knob securely.

OPERATION

Fig. 12

DEPTH ADJUSTMENT

KNOB

DEPTH OF CUT

SCALE

BASE

Fig. 11

SWITCH

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB141LZ Manuel de l'opérateur Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Ryobi CSB141LZ