Ryobi CSB141LZ Manuel de l'opérateur télécharger pdf (Page 17)

16 17

OPERATION

USING THE LASER GUIDES

See Figure 16.

WARNING:

Do not stare into the laser beams or turn the lasers on

when the tool is not in use. Failure to heed this warning

could result in possible serious personal injury.

The laser guides will generate a red colored laser beam

on the work surface in front of and behind the saw when

turned on. The front laser aids in following the line of cut

when cutting the workpiece. The rear laser aids in aligning

plunge cuts and following the kerf when exiting the

workpiece.

NOTE: The laser units come from the factory already installed

and aligned. If the lasers become misaligned after time, refer

to the Adjustments section later in this manual.

n Mark the line to be cut on the workpiece.

n Adjust the depth and angle of the cut as needed.

n Plug the tool into a power supply and press the laser

guide button to activate the laser.

n Start the motor.

NOTE: Do not touch the blade to the workpiece until the

saw has reached maximum speed.

n Slowly push the saw forward into the workpiece.

NOTE: Keep the laser beam on the marked line on the

workpiece for precision cutting.

n Once the cut is complete, allow the saw to come to a

complete stop before turning off the laser.

n Unplug the saw.

LENGTH OF CUT SCALE

See Figure 17.

The saw is equipped with a length of cut scale on its base. It

is parallel with the saw blade and you can use it to measure

the distance into the material the blade cuts.

NOTE: Six inches is the maximum length of cut that you can

measure. Also, it is accurate only when the depth of cut is

set at full maximum depth.

Fig. 16

LASER GUIDE

BUTTON

Fig. 17

LENGTH OF CUT

SCALE

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi CSB141LZ Manuel de l'opérateur Page 17

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Ryobi CSB141LZ