Ryobi P500 Manuel d'utilisateur télécharger pdf (Page 14)

14 15

OPERATION

Fig. 6

Fig. 7

Fig. 8

Fig. 9

INCORRECT

SUPPORT

CORRECT

SUPPORT

KICKBACK - BLADE SET TOO DEEP

CORRECT BLADE DEPTH SETTING = BLADE EXPOSED 1/4 in.

(6.35 mm) OR LESS ON UNDERSIDE OF WORKPIECE

WARNING:

Battery tools are always in operating condition. There-

fore, switch should always be locked when not in use or

carrying at your side.

KICKBACK

See Figures 6 - 9.

Kickback occurs when the blade stalls rapidly and the saw

is driven back towards you. Blade stalling is caused by any

action which pinches the blade in the wood.

DANGER:

Release switch immediately if blade binds or saw stalls.

Kickback could cause you to lose control of the saw. Loss

of control can lead to serious injury.

To guard against kickback, avoid dangerous practices such

as the following.

n Setting blade depth incorrectly.

n Sawing into knots or nails in workpiece.

n Twisting the blade while making a cut.

n Making a cut with a dull, gummed up, or improperly set

blade.

n Supporting the workpiece incorrectly.

n Forcing a cut.

n Cutting warped or wet lumber.

n Operating the tool incorrectly or misusing the tool.

To lessen the chance of kickback, follow these safety prac-

tices.

n Keep the blade at the correct depth setting. The depth

setting should not exceed 1/4 in. below the material being

cut.

n Inspect the workpiece for knots or nails before cutting.

Never saw into a knot or nail.

n Make straight cuts. Always use a straight edge guide

when rip cutting. This helps prevent twisting the blade.

n Use clean, sharp, and properly set blades. Never make

cuts with dull blades.

n Support the workpiece properly before beginning a cut.

n Use steady, even pressure when making a cut. Never

force a cut.

n Do not cut warped or wet lumber.

n Hold the saw firmly with both hands and keep your body

in a balanced position so as to resist the forces if kickback

should occur.

WARNING:

When using the saw, always stay alert and exercise con-

trol. Do not remove the saw from the workpiece while the

blade is moving.

WRONG

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Commentaires sur ces manuels

Pas de commentaire

Ryobi P500 Manuel d'utilisateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Ryobi P500