Ryobi P500 Manuel d'utilisateur télécharger pdf (Page 20)

20 21

OPERATION

n Release the trigger and allow the blade to come to a

complete stop.

n Lift the saw from the workpiece.

n Clear corners out with a hand saw or sabre saw.

WARNING:

Never tie the lower blade guard in a raised position. Leav-

ing the blade exposed could lead to serious injury.

POCKET CUTTING

See Figure 23.

WARNING:

Always adjust bevel setting to zero before making a

pocket cut. Attempting a pocket cut at any other setting

can result in loss of control of the saw possibly causing

serious injury.

n Adjust the bevel setting to zero.

n Set the blade to the correct blade depth setting.

n Swing the lower blade guard up using the lower blade

guard handle.

NOTE: Always raise the lower blade guard with the handle

to avoid serious injury.

n Hold the lower blade guard by the handle.

n Rest the front of the base flat against the workpiece with

the rear of the handle raised so the blade does not touch

the workpiece.

n Start the saw and let the blade reach full speed.

n Guide the saw into the workpiece and make the cut.

WARNING:

Always cut in a forward direction when pocket cutting.

Cutting in the reverse direction could cause the saw to

climb up on the workpiece and back toward you.

Fig. 23

POCKET CUT

LOWER BLADE GUARD

LOWER BLADE

GUARD HANDLE

1 2 ... 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Ryobi P500 Manuel d'utilisateur Page 20