Ryobi P551 Manuel de l'opérateur télécharger pdf (Page 18)

Miter

tabLe

Miter

tabLe

Miter

tabLe

coMbination

square

coMbination

square

coMbination

square

beveL

Lock

knob

beveL

Lock

knob

beveL

Lock

knob

Miter

fence

Miter

fence

Miter

fence

bLade

33.9

ASSEMBLY

scaLe

indicator

Miter

scaLe

indicator

screw

beveL

scaLe

SQUARING THE BLADE TO THE MITER TABLE

See Figures 20 - 23.

 Remove the battery pack from the tool.

 Pull the saw arm all the way down and engage the lock

pin to hold the saw arm in transport position.

 Lift the miter lock lever.

 Rotate the miter table until the pointer aligns with zero

on the miter scale.

 Push the miter lock lever down to lock the miter table.

 Loosen bevel lock knob and set saw arm at 0

bevel (blade

set 90

to miter table). Tighten bevel lock knob.

 Place a square against the miter table and the flat part

of saw blade.

NOTE: Make sure that the square contacts the flat part

of the saw blade, not the blade teeth.

 Rotate the blade by hand and check the blade-to-table

alignment at several points.

 The edge of the square and the saw blade should be

parallel as shown in figure 21.

 If the top or bottom of the saw blade angles away from

the square as shown in figures 22 and 23, adjustments

are needed.

 Loosen the bevel lock knob.

 Adjust positive stop adjustment screw to bring saw blade

into alignment with the square. See Positive Stop Adjust-

ment in the Adjustments section.

 Retighten bevel lock knob. Recheck blade-to-table align-

ment.

NOTE: The above procedure can be used to check blade

squareness of the saw blade to the miter table at both 0

and 45

angles.

The saw has two scale indicators, one on the bevel scale

and one on the miter scale. After squaring adjustments have

been made, it may be necessary to loosen the indicator

screws and reset them to zero.

Fig. 21

correct view of bLade square with Miter tabLe

view of bLade not square with Miter tabLe,

adJustMents are required

Fig. 22

Fig. 23

view of bLade not square with Miter tabLe,

adJustMents are required

Fig. 20

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 31 32

Commentaires sur ces manuels

Pas de commentaire

Ryobi P551 Manuel de l'opérateur Page 18

Commentaires sur ces manuels

Produits connexes et manuels pour Scies circulaires Ryobi P551