Ryobi P551 Manuel de l'opérateur télécharger pdf (Page 24)

OPERATION

 Place the workpiece flat on the miter table with one edge

securely against the fence. If the board is warped, place

the convex side against the fence. If the concave edge

of a board is placed against the fence, the board could

collapse on the blade at the end of the cut, jamming the

blade.

 When cutting long pieces of lumber or molding, support

the opposite end of the stock with a roller stand or with

a work surface level with the saw table. See Figure 32.

 Align the cutting line on the workpiece with the edge of

saw blade.

 Grasp the stock firmly with one hand and secure it against

the fence. Use the optional work clamp or a C-clamp to

secure the workpiece when possible.

 Before turning on the saw, perform a dry run of the cutting

operation just to make sure that no problems will occur

when the cut is made.

 Grasp the saw handle firmly. Depress the switch lock

with thumb then squeeze the switch trigger. Allow several

seconds for the blade to reach maximum speed.

 Slowly lower the blade into and through the workpiece.

 Release the switch trigger and allow the saw blade to stop

rotating before raising the blade out of the workpiece. Wait

until the blade stops before removing the workpiece from

the miter table.

Fig. 32

Long

workpiece

supports

TO SUPPORT LONG WORKPIECES

See Figure 32.

Long workpieces need extra supports. Supports should be

placed along the workpiece so it does not sag. The support

should let the workpiece lay flat on the base of the saw and

worktable during the cutting operation. Use the optional work

clamp or a C-clamp to secure the workpiece.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Pas de commentaire

Ryobi P551 Manuel de l'opérateur Page 24