Ryobi RY09600 Manuel d'utilisateur télécharger pdf (Page 13)

11 — English

OPERATION

STARTING AND STOPPING

See Figures 9 - 11.

When starting the product for the first time or when the bat-

tery voltage is low, it may be necessary to manually start

this product.

FOR ELECTRIC START:

To start a cold engine:

DO NOT engage the throttle until the engine starts and

runs.

Lay the product on a flat, bare surface.

PRIME - Press the primer bulb 7 times.

SET the start lever to the START position.

PRESS ignition switch.

Push the throttle to run.

NOTE: Engaging and releasing the throttle releases the start

lever to the RUN position.

To start a warm engine:

PRESS ignition switch.

To stop the engine:

Press and hold the switch in the stop “ ” position until

the engine stops.

FOR MANUAL START:

To start a cold engine:

DO NOT engage the throttle until the engine starts and

runs.

Lay the product on a flat, bare surface.

PRIME - Press the primer bulb 7 times.

SET the start lever to the START position.

PULL the recoil starter until the engine starts.

Push the throttle to run.

NOTE: Engaging and releasing the throttle releases the start

lever to the RUN position.

To start a warm engine:

PULL the recoil starter until the engine starts.

To stop the engine:

Press and hold the switch in the stop “ ” position until

the engine stops.

IF ASSISTANCE IS REQUIRED STARTING THIS

PRODUCT:

Do not return this product to the retail store where it was

purchased. Please call our Customer Service Department

for any issues you may have.

For Help Call: 1-800-860-4050.

WARNING:

Keep away from all hot surfaces of the blower. Failure to

do so could result in possible serious personal injury.

OPERATING THE BLOWER

See Figure 12.

 Slip arm through harness strap and onto shoulder, then

repeat for the other shoulder. Adjust the straps to a

comfortable position. Refer to Adjusting Harness Straps

earlier in this manual. Remove unit for starting.

 Start the blower. Refer to Starting and Stopping earlier

in this manual.

 Put on the blower again. The unit should be operated on

the operator’s right side as shown.

 To keep from scattering debris, blow around the outer

edges of a debris pile. Never blow directly into the center

of a pile.

 Operate power equipment at reasonable hours only —

not early in the morning or late at night when people

might be disturbed. Comply with the times listed in local

ordinances.

 To reduce sound levels, limit the number of pieces of

equipment used at any one time.

 Operate blower at the lowest possible throttle speed to

do the job.

 Check your equipment before operation, especially the

muffler, air intakes, and air filters.

 Use rakes and brooms to loosen debris before blowing.

In dusty conditions, slightly dampen surfaces when water

is available.

 Conserve water by using power blowers instead of hoses

for many lawn and garden applications, including areas

such as gutters, screens, patios, grills, porches, and

gardens.

 Watch out for children, pets, open windows, or freshly

washed cars, and blow debris safely away.

 Use the wide sweeper nozzle for larger volume, so the

air stream can work close to the ground.

 After using blowers or other equipment, CLEAN UP!

Dispose of debris properly.

CAUTION:

Do not place blower on top of or near loose debris.

Debris may be sucked into blower intake vent resulting

in possible damage to the unit.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 49 50

Commentaires sur ces manuels

Pas de commentaire

Ryobi RY09600 Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Ventilateurs Ryobi RY09600