Ryobi RY09600 Manuel d'utilisateur Page 15

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 50
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 14
13 — English
IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM CONTACT YOUR AUTHORIZED SERVICE DEALER.
TROUBLESHOOTING
Problem Possible Cause Solution
Engine will not start. No spark.
No fuel.
Engine is flooded.
Starter rope pulls harder now than when
new.
Check spark. Remove spark plug. Reattach
the spark plug cap and lay spark plug on
metal cylinder. Pull the starter rope and
watch for spark at spark plug tip. If there
is no spark, repeat test with a new spark
plug.
Push primer bulb until bulb is full of fuel.
If bulb does not fill, primary fuel delivery
system is blocked. Contact a servicing
dealer. If primer bulb fills, engine may be
flooded, proceed to next item.
Remove spark plug, turn unit so spark plug
hole is aimed at the ground. Rotate the
choke dial to “RUN” position and pull starter
cord 10 to 15 times. This will clear excess
fuel from engine. Clean and reinstall spark
plug. Pull starter three times with choke dial
at “RUN”. If engine does not start, rotate
choke dial to “FULL CHOKE” position and
repeat normal starting procedure. If engine
still fails to start, repeat procedure with a
new spark plug.
Contact a servicing dealer.
Engine starts but will not accelerate. Engine requires approximately three
minutes to warm up.
Allow engine to completely warm up. If
engine does not accelerate after three
minutes, contact a servicing dealer.
Engine starts but will only run at high speed
at half choke.
Carburetor requires adjustment. Contact a servicing dealer.
Engine does not reach full speed and emits
excessive smoke.
Check lubricant fuel mixture.
Air filter is dirty.
Spark arrestor screen is dirty.
Use fresh fuel and the correct 2-cycle
lubricant mix.
Clean air filter. Refer to Cleaning the Air
Filter Screen earlier in this manual.
Contact a servicing dealer.
Engine starts, runs, and accelerates but
will not idle.
Idle speed screw on carburetor needs
adjustment.
Turn idle speed screw clockwise to
increase idle speed. See figure 12.
Vue de la page 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 49 50

Commentaires sur ces manuels

Pas de commentaire